Converter Module Installation
Installing and Removing SFP or SFP+ Modules
Caution
Note
Installation Notes for the Cisco TwinGig and OneX Converter Modules
12
Figure 4
Removing a Converter Module from the Switch (TwinGig
Shown)
This section describes how to install and remove SFP or SFP+ modules in the
converter module slots. You must have the converter module installed in a
10-Gigabit Ethernet switch slot to use SFP or SFP+ modules with the switch.
Figure 5 on page 14
shows the converter module in the switch with the SFP
modules installed.
For detailed information about installing, removing, cabling, and troubleshooting
SFP and SFP + modules, see the module documentation that shipped with your
device.
To avoid damage to the converter module, first install the converter module in the
switch 10-Gigabit Ethernet X2 slot before installing the SFP or SFP+ modules.
Do not install or remove an SFP or SFP+ module with cables attached to it because
of the potential damage to the cables, the cable connector, or the optical interfaces in
the SFP module. Disconnect all cables before removing or installing an SFP or SFP+
module.
4 5
4 6
4 7
4 8
4 7 X
4 9
X 2 -1
X 2 -2
5 1
t 3 7 5 0 -
4 8 X
E
S E R IE S
P o E - 4 8
5 0
5 2
78-17572-04