Thermo Scientific TSX Series Installation And Operation Manual page 19

7.4 Drawers
7.4.1 Removing the Drawers
Thermo Scientific
Drawers can be ordered as an accessory for this unit.
Drawers are shipped in a factory installed position that promotes uniform
spacing between the drawers. The drawer slides are adjustable to higher and
lower positions in the cabinet. You can position these slides in the vertical slots
which are spaced at one-inch intervals. The drawers must be removed in order to
adjust the position of the drawer slides.
The maximum drawer capacity is 27 kg (60 lbs).
To remove the drawers, complete the following steps (refer to Figure 4):
1. Pull the drawer towards you until the slides are fully extended.
2. Lift the back of the drawer to disengage the mounting tabs from the
slots on the slides.
Note The drawers fit snugly between the slides. Push the back to the drawer
from underneath to remove the drawer.
3. Raise the back of the drawer almost to a vertical position and disengage
the front mounting clips from the sides.
Figure 4. Drawer Removal
Label Description
1 Tabs
2 Drawer slide
3 Slot
TSX -20°C Laboratory and Enzyme Freezers
Installation
15