Installation; Location - Thermo Scientific TSX Series Installation And Operation Manual

7 Installation

7.1 Location

7.1.1 Installation Instructions
(Models A/D from Table 1)
7.1.2 Installation Instructions
(Models V/Y/Z from Table 1)
Thermo Scientific
WARNING: Do not exceed the electrical rating printed on the data plate
located on the upper left side of the unit.
CAUTION: Do not move the unit using the drain pan on the back. This
could cause damage to the equipment.
Install the unit on a level area free from vibration with a minimum of 6 inches of
space on the sides and rear and 12 inches at the top. Do not position the
equipment in direct sunlight or near heating diffusers, radiators, or other sources
of heat.
WARNING: Do not move the unit while loaded. Unit shall always be
moved when empty and by pushing slowly at handle level or lower on the
unit. Be especially careful on any uneven surfaces.
The unit must be level both front to back and side to side when installed. If
the unit is out of level, you may need to shim the corners or casters with thin
of metal. Be sure to set the brakes for units equipped with casters.
CAUTION: An unlevel unit may result in instability and performance
issues for the doors and drawers.
The unit must be level both front to back and side to side when installed. If the
unit is out of level, you may need to shim the corners or casters with thin sheets
of metal. Be sure to set the brakes for units equipped with casters.
CAUTION: An unlevel unit may result in instability and performance
issues for the doors and drawers.
WARNING: The freezer must be secured by the anti-tip bracket supplied.
Unless properly installed, the freezer could tip when shelves/drawers/baskets
are loaded. Injury and damage to the equipment and contents may result
from the freezer tipping.
This freezer has been designed to meet all recognized industry tip standards for
all normal conditions when anti-tip bracket is installed and properly engaged.
TSX -20°C Laboratory and Enzyme Freezers
Installation
9