Getting Started; Running Your First Example - ST STM32F2 Series User Manual

Getting started

4 Getting started
4.1

Running your first example

This section explains how to run a first example within STM32CubeF2, using as illustration
the generation of a simple led toggle on STM322xG_EVAL board:
1. Download the STM32CubeF2 FW package
2. Unzip the package into a directory of your choice. Make sure not to modify the package
structure shown in the
location close to your root volume (for example C:\Eval or G:\Tests) because
some IDEs encounter problems when the path length is too high.

Browse to \Projects\STM322xG_EVAL\Examples

Open \GPIO folder, and then open \GPIO_EXTI folder

Open the project with your preferred toolchain (see the examples below)

Rebuild all files and load your image into the target memory

Run the example: the behavior of the program is described in the readmed.txt file
available with the example (for example the usage of User Button or the meaning of the
LEDs).
12/19
Figure 3. It is also recommended to copy the package at a
DocID026120 Rev 2
UM1739