Clear Space Above The Printer - Stratasys Objet24 V2 Site Preparation Manual

If your specific work area does not meet this minimum floor plan, consult
with customer support to consider other possible arrangements.
The system should not be located near heavy machinery (such as
generators) that may cause electrical interference or high vibration levels.
The system should be protected from sprinklers or pipes carrying liquids
above the system. Similarly, do not place a Water Jet (used for cleaning
models) within 5 meters (16 feet) of the printer.
The server workstation must be located within 5 meters (16 feet) of the
printer. The monitor, keyboard and mouse of the workstation are shared
with the printer computer (the keyboard and the mouse must be USB‐type
devices).
Shelves and cabinets may be located in the vicinity of the printer to allow
convenient storage of tools, parts, accessories, manuals and containers or
model/support material.
The temperature requirements for material storage are stated in Section 5.11.1,
Storage and Transport Conditions on page 18.
4.2 Table Height & Strength
The height of the table should be 62–72 cm (2 feet to 2 feet, 4 inches). This
establishes a working height of 100–110 cm (2 feet, 3 inches to
2 feet, 7 inches).
Warning:
Four (4) people are required to lift the printer onto the table.
The stand/table must be capable of carrying a load of at least 100 kg
(220 lb). For the weight of the printer, refer to Table 1, "Printer size and
weight," on page 6.
The stand/table must be level.

4.3 Clear Space Above the Printer

A clearance of 60 cm (2 feet) must be maintained above the printer to
provide space for opening the top cover and for servicing.
DOC-04002
Objet Desktop 3-D Printer Site Preparation Guide
11 Rev. D2