White Balance - NANO CAM NCP-DVRFHD User Manual

WHITE BALANCE

The White Balance setting is used to manually adjust the settings used to counteract different light conditions� This setting is set to Auto
by default� To change the White Balance setting follow the instructions below�
1� Enter the Photo screen�
2� Press the  Button to enter the Photo Menu�
3� Use the  Up and  Down Buttons to navigate the Photo Menu and highlight the White Balance setting and press OK (Rec/Ok) to
select�
4� Use the  Up and  Down Buttons to highlight your required setting, then press the OK (Rec/Ok) button to confirm your selection�
Note:
• Menus cannot be accessed while the camera is recording� Please stop the recording before attempting to access the menu�
• This setting can only be accessed through the Photo Menu, please make sure that you are in the Photo screen when you access the
menu�
29