Settings Menu; Park Mode - NANO CAM NCP-DVRFHD User Manual

SETTINGS MENU

The Settings menu is used to adjust the cameras Settings�
To Access the Settings menu, ensure that the camera is not recording and press the  Menu Button to enter the Video Menu, then press
the  Menu Button again to enter the Settings menu�

PARK MODE

When activated, Park Mode will monitor the DVR's G Sensor after you have turned off your vehicle� If an impact is detected the DVR will
power up and record a 60 second clip� To set Park Mode, follow the instructions below�
1� Ensure that the Car DVR is not recording�
2� Press the  Menu Button to enter the Video Menu�
3� Press the  Menu Button again to enter the Settings Menu�
4� Use the  Up and  Down Buttons to navigate the Settings Menu and highlight the Parking Mode setting and press OK (Rec/Ok) to
select�
5� Use the  Up and  Down Buttons to highlight either OFF or ON, then press the OK (Rec/Ok) button to confirm your selection�
Note:
• Menus cannot be accessed while the camera is recording� Please stop the recording before attempting to access the menu�
• Park mode requires the DVR's internal battery to be fully charged�
• Park Mode is activated when an impact is detected and will record from that point onward�
23