2.2 POWERING THE CAR DVR ON / OFF
AUTO POWER ON/OFF
When the Car DVR is correctly installed and connected to your vehicle's 12v power supply, the Car DVR will automatically power up and
start recording when the vehicle accessories are activated�
MANUAL POWER ON/OFF AND RESET
MANUAL POWER ON
Hold the Power button on the top of the camera until the NanoCam Plus start up screen appears�
POWER OFF
Make sure that recording has been stopped and then press the Power button on the top of the car DVR� After powering down the device
please wait for 10 seconds before turning the Car DVR back on�
RESET THE DEVICE
If the Car DVR does not function normally, try restarting the car DVR� To restart the car DVR, with a flattened paper clip press the small
button in the middle of the underside of the Car DVR�
12