Motion Detection; Recording Audio - NANO CAM NCP-DVRFHD User Manual

MOTION DETECTION

Motion Detection is used to pause recording when no motion is detected in front of the camera, and to start recording when motion is
detected again� To activate the Motion Detection setting follow the instructions below�
1� Press the OK (Rec/Ok) Button to stop the Car DVR from recording�
2� Press the  Button to enter the Video Menu�
3� Use the  Up and  Down Buttons to navigate the Settings Menu and highlight the Motion Detection setting and press
OK (Rec/Ok) to select�
4� Use the  Up and  Down Buttons to highlight either OFF or ON, then press the OK (Rec/Ok) button to confirm your selection�
Note:
• Menus cannot be accessed while the camera is recording� Please stop the recording before attempting to access the menu�

RECORDING AUDIO

The Recording Audio setting allows you to mute the microphone during recording, or set it to record� To set your recording preferences,
please follow the instructions below�
1� Press the OK (Rec/Ok) Button to stop the Car DVR from recording�
2� Press the  Button to enter the Video Menu�
3� Use the and Buttons to navigate the Settings Menu and highlight the Recording Audio setting and press OK (Rec/Ok) to select�
4� Use the  Up and  Down Buttons to highlight either OFF or ON, then press the OK (Rec/Ok) button to confirm your selection�
20