Diagnostic Facilities; Manufacturing Test Process - Motorola 700 Series Installation And Use Manual

The address appears as:

Diagnostic Facilities

The 162Bug package includes a set of hardware diagnostics for
testing and troubleshooting the MVME162LX. To use the
diagnostics, switch directories to the diagnostic directory. If you are
in the debugger directory, you can switch to the diagnostic
directory with the debugger command Switch Directories (
diagnostic prompt
162-Diag>
appears. Refer to the Debugging Package for Motorola 68K CISC CPUs
User's Manual for complete descriptions of the diagnostic routines
available and instructions on how to invoke them. Note that some
diagnostics depend on restart defaults that are set up only in a
particular restart mode. The documentation for such diagnostics
includes restart information.

Manufacturing Test Process

During the manufacturing process for MVME162LXs, the
manufacturing test parameters and testing state flags are stored in
NVRAM. These strings are installed during the manufacturing
process and result in the product performing manufacturing tests.
None of these tests harm the product or system into which a board
is installed. Entering an ASCII break on the console port from a
terminal terminates these tests.
The two state flags that start the test processes are:
FLASH EMPTY$00122984
and
Burnin test$00000000
GPCSR0 GPCSR1
Diagnostic Facilities
). The
SD
3-25
3