Motorola 700 Series Installation And Use Manual page 125

Table A-1. ENV Command Parameters (Continued)
ENV Parameter and Options
Auto Boot at power-up only
[Y/N]
Auto Boot Controller LUN
Auto Boot Device LUN
Auto Boot Abort Delay
Auto Boot Default String
[Y(NULL String)/(String)]
ROM Boot Enable [Y/N]
ROM Boot at power-up only
[Y/N]
ROM Boot Enable search of
VMEbus [Y/N]
ROM Boot Abort Delay
ROM Boot Direct Starting
Address
ROM Boot Direct Ending
Address
Set Environment to Bug/Operating System
Default Meaning of Default
Y Auto Boot is attempted at power-up reset
only.
00 LUN of a disk/tape controller module
currently supported by the Bug. Default
is $0.
00 LUN of a disk/tape device currently
supported by the Bug. Default is $0.
15 The time in seconds that the Auto Boot
sequence will delay before starting the
boot. The purpose for the delay is to allow
you the option of stopping the boot by
use of the Break key. The time value is
from 0 through 255 seconds.
You may specify a string (filename) which
is passed on to the code being booted.
Maximum length is 16 characters. Default
is the null string.
N ROMboot function is disabled.
Y ROMboot is attempted at power up only.
N VMEbus address space will not be
accessed by ROMboot.
00 The time in seconds that the ROMboot
sequence will delay before starting the
boot. The purpose for the delay is to allow
you the option of stopping the boot by
use of the Break key. The time value is
from 0 through 255 seconds.
FF800000 First location tested when the Bug
searches for a ROMboot Module.
FFDFFFFC Last location tested when the Bug
searches for a ROMboot Module.
A
A-5