Configuring The Industrypacks - Motorola 700 Series Installation And Use Manual

Configure and Environment Commands
A
ENV Parameter and Options
VMEC2 GCSR Group Base
Address
VMEC2 GCSR Board Base
Address
VMEbus Global Time Out
Code
Local Bus Time Out Code
VMEbus Access Time Out
Code
Configuring the IndustryPacks
A-14
Table A-1. ENV Command Parameters (Continued)
Default
asks the following series of questions to set up IndustryPacks
ENV
(IPs) on MVME162LX VMEmodules.
The MVME162LX Embedded Controller Programmer's Reference Guide
describes the base addresses and the IP register settings. Refer to
that manual for information on setting base addresses and register
bits.
The IP2 ASIC on the MVME162LX supports up to four
Note
IndustryPack (IP) interfaces, designated IP_a through
IP_d. The 700/800-series MVME162LX itself
accommodates two IPs: IP_a and IP_b. In the following
discussion, the segments applicable to IP_c and IP_d
are not used in the 700/800-series MVME162LX.
IP A Base Address
IP B Base Address
IP C Base Address
IP D Base Address
Meaning of Default
D2 Specifies the group address ($FFFFXX00)
in Short I/O for this board. Default = $D2.
00 Specifies the base address ($FFFFD2XX)
in Short I/O for this board. Default = $00.
01 Controls the VMEbus timeout when the
MVME162LX is operating as system
controller. Default $01 = 64 µs.
02 Controls the local bus timeout. Default
$02 = 256 µs.
02 Controls the local bus to VMEbus access
timeout. Default $02 = 32 ms.
= 00000000?
= 00000000?
= 00000000?
= 00000000?