Miele H 7464 BP Operating And Installation Instructions page 94

Cleaning and care
Finishing off the pyrolytic cleaning
process
When the time remaining has counted
down to 0:00 h, a message will appear
in the display to tell you that the door is
unlocking.
Process finished will appear in the display
and a buzzer will sound as soon as the
door has been unlocked.
 Switch the oven off.
The visual and acoustic signals will
switch off.

Risk of injury caused by hot
surfaces.
At the end of the pyrolytic cleaning
programme, the oven will still be very
hot. You could burn yourself on the
heating elements, oven compartment
or accessories.
Allow the heating elements, oven
compartment and accessories to
drop to a safe temperature before
removing any pyrolytic residues and
lubricating the side runners.
 Clean the oven compartment and
pyrolytic accessories to remove any
pyrolytic residues (e.g. ash) that may
have built up depending on the
degree of soiling in the oven.
 Add a few drops of heat resistant
cooking oil to some kitchen paper
and use this to lubricate the side
runners.
94
Most residues can be removed with
warm water, a little washing-up liquid
and a clean sponge or a clean, damp
microfibre cloth.
Depending on the level of soiling, a
visible deposit could build up on the
glass on the inside of the oven door.
This can be removed with a
dishwashing sponge, a glass scraper
or a stainless steel spiral scourer and
a little washing-up liquid.
There is a delicate fibreglass seal
around the oven compartment to
seal the glass in the oven door. This
can be damaged by rubbing or
scouring.
Avoid cleaning the fibreglass seal.
Enamelled surfaces can be
permanently discoloured by spilt fruit
juices. Such discolouration does not
affect the properties of the enamel.
Do not attempt to remove these
stains.
Extending and retracting the FlexiClip
runners
After cleaning, discolouration or light
patches can remain on the FlexiClip
runners. However this does not affect
their operation.
 Extend and retract the FlexiClip
runners several times after running
the pyrolytic cleaning programme.