Mazda CX-5 Manual page 426

When Driving
Tyre Pressure Monitoring System
▼ Tyres and Wheels
CAUTION
When inspecting or adjusting the tyre air
pressures, do not apply excessive force to
the stem part of the wheel unit. The stem
part could be damaged.
Changing tyres and wheels
The following procedure allows the TPMS
to recognise a tyre pressure sensor's
unique ID signal code whenever tyres or
wheels are changed, such as changing to
and from winter tyres.
NOTE
Each tyre pressure sensor has a unique ID
signal code. The signal code must be
registered with the TPMS before it can
work. The easiest way to do it is to have
an Authorised Mazda Dealer change your
tyre and complete ID signal code
registration.
When having tyres changed at an
Authorised Mazda Dealer
When an Authorised Mazda Dealer
changes your vehicle's tyres, they will
complete the tyre pressure sensor ID
signal code registration.
When changing tyres yourself
If you or someone else changes tyres, you
or someone else can also undertake the
steps for the TPMS to complete the ID
signal code registration.
1. After tyres have been changed, switch
the ignition ON, then back to ACC or
OFF.
2. Wait for about 15 minutes.
4-268
3. After about 15 minutes, drive the
vehicle at a speed of at least 25 km/h
(16 mph) for 10 minutes and the tyre
pressure sensor ID signal code will be
registered automatically.
NOTE
If the vehicle is driven within about 15
minutes of changing tyres, the tyre
pressure monitoring system warning light
will flash because the sensor ID signal
code would not have been registered. If
this happens, park the vehicle for about 15
minutes, after which the sensor ID signal
code will register upon driving the vehicle
for 10 minutes.
Replacing tyres and wheels
CAUTION
When replacing/repairing the tyres or
wheels or both, have the work done by
an Authorised Mazda Dealer, or the tyre
pressure sensors may be damaged.
The wheels equipped on your Mazda are
specially designed for installation of the
tyre pressure sensors. Do not use
non-genuine wheels, otherwise it may
not be possible to install the tyre pressure
sensors.
Be sure to have the tyre pressure sensors
installed whenever tyres or wheels are
replaced.
When having a tyre or wheel or both
replaced, the following types of tyre
pressure sensor installations are possible.
The tyre pressure sensor is removed

from the old wheel and installed to the
new one.