Mazda CX-5 Manual page 340

When Driving
i-ACTIVSENSE
When the ignition is switched to ACC or OFF and then the engine is started again, the

system automatically sets the distance-between-vehicles to the previous setting.
How to change the set vehicle speed
To accelerate/decelerate using the SET
switch
When you press the SET switch, the
vehicle accelerates and when you press the
SET switch, it decelerates.
European
models
Short press 1 km/h (1 mph) 5 km/h (5 mph)
Long press
NOTE
For example, the set vehicle speed is
changed by pressing the SET switch 4
times as follows:
(European models)
The vehicle speed accelerates or
decelerates by 4 km/h (4 mph).
(Except European models)
The vehicle speed accelerates or
decelerates by 20 km/h (20 mph).
To increase speed using accelerator
pedal
Depress the accelerator pedal and press
and release the SET switch or SET
switch at the desired speed. If the switch is
not operated, the system returns to the set
speed after you release your foot from the
accelerator pedal.
CAUTION
The warnings and brake control do not
operate while the accelerator pedal is
depressed.
4-182
Except Euro-
pean models
10 km/h (5 mph)
NOTE
The setting speed can be changed by

operating the SET switch or SET
switch during stop hold control.
When accelerating using the SET

switch while in headway control, the set
vehicle speed can be adjusted but
acceleration is not possible. If there is
no longer a vehicle ahead, acceleration
continues until reaching the set vehicle
speed. For the set vehicle speed, check
the set vehicle speed indication in the
display.
When depressing the accelerator pedal,

the inter-vehicle distance indication in
the display changes to the white-line
indication.
(European models)

When switching to a passing lane and
operating the direction indicator, the
system provides more acceleration
automatically if it determines that more
acceleration is required. Drive while
being careful of the road ahead because
you could approach the vehicle ahead
too closely.
Cancelling the system
When the following operations are
performed, the MRCC with Stop & Go
function system is cancelled, and the
MRCC with Stop & Go function set
indication (green) switches to the MRCC
with Stop & Go function main indication
(white) at the same time.
The OFF/CANCEL switch is pressed.

The brake pedal is depressed.

The parking brake is applied.
