Mazda CX-5 Manual page 173

NOTE
Under the following conditions, a period
of time is required to stop engine idling
The battery power is depleted for some

reasons such as the vehicle has not been
driven for a long period.
The ambient temperature is high or low.

After the battery terminals are

disconnected for some reasons such as
for battery replacement.
(SKYACTIV-D 2.2)

After PM removal is performed by the
diesel particulate filter (DPF).
Engine does not restart
If the following operations are performed
while the idling is stopped, the engine will
not restart for safety reasons. In such
cases, start the engine using the normal
method.
(European model)

The bonnet is opened.

The driver's seat belt is unfastened

and the driver's door is opened.
Engine-stop period is short or time until
next engine idle stop is long
The ambient temperature is high or low.

The battery power is depleted.

Power consumption by the vehicle's

electrical parts is high.
Engine restarts automatically while
engine idling is stopped
Under the following conditions, the engine
restarts automatically.
The i-stop OFF switch is pressed until

the beep sounds.
The air conditioner is operated with the

airflow mode in the
(Automatic air-conditioning)

position.
Start/Stop Engine
The temperature setting dial of the air

conditioner is in the maximum heating
or maximum cooling (A/C ON)
position.
The cabin temperature is largely

different from the set temperature of
the air conditioner.
The brakes are released slightly on a

slope and the vehicle begins to move.
Two minutes have elapsed since the

idling was stopped.
The battery power is depleted.

(Automatic transaxle)

The accelerator pedal is depressed

with the selector lever in the D or M
(not in second gear fixed mode)
position.
The selector lever is shifted to the R

position.
The selector lever is shifted from N or

P position to D or M (not in second
gear fixed mode) position.
The steering wheel is operated with

the selector lever in the D or M (not in
second gear fixed mode) position.
The selector lever is in the M position

and the second gear fixed mode is
selected.
(Except European model)

(Manual transaxle)

With the shift lever in the neutral
position, the driver's seat belt is
unfastened, the driver's door is
opened, or the bonnet is opened.
(Automatic transaxle)

With the selector lever in the P or N
position, or the D/M range, the
driver's seat belt is unfastened, the
driver's door is opened, or the bonnet
is opened.
When Driving
4-15