Cursor
measurements
Measurements
Measure
Equipment
Screen
Battery
Size
Appendix B: ADO 102/ADO 104 oscilloscope accessories
ADO 102 oscilloscope:
- User manual (CD)
- Certificate
- A dedicated high-voltage
ignition probe (Found 1: 3000)
- 1: 1/10: 1 probe two
- Multimeter table pen one pair
- Four broken wire needle
- Lithium battery × 2
- Battery Charger
- Portable Kit
- USB cable one
Appendix C: routine maintenance and cleaning
Routine maintenance
Do not store or leave the instrument in where the LCD display will be exposed to direct
sunlight for a long time.
Do not allow sprays, liquids and solvents touches on the instrument or probe, to avoid
damage to the instrument and probe.
Please charge the battery in the battery is finished using the situation.
Clean
Regularly inspect the instrument and probe according to operating conditions.
Please follow the steps below to clean the outer surface of the instrument:
1.Use external dust soft cloth to wipe the instrument and probe. When cleaning the LCD
screen, be careful not to scratch the clear plastic protective screen.
Support time and voltage cursors
Manual
Peak and frequency
3.2-inch, 16-bit true color, TFT, 320 * 240
3000 + mA lithium battery (single cell about four hours of
continuous work)
115 * 180 * 35 (mm)
ADO 104 oscilloscope:
- User manual (CD)
- Certificate
- Two dedicated
high-voltage ignition probe (1: 3000)
- 1: 1/10: 1 probe four
- Multimeter table pen one pair
- Six broken wire needle
- lithium batteries × 2
- Battery Charger
- Portable Kit
- USB cable one
39