Table of Contents
Advertisement
press "OK" button, enter the change, up and down keys to select a topic style and then
press "OK" button to confirm, the unit provides four display style theme.
5) to restore the factory: the main menu, select "System Settings" button, press the "OK"
button to enter the settings interface, via the arrow keys to select "Factory" press "OK"
button, enter the change, left and right keys to select OK or Cancel, then press "OK"
button to confirm the WTR.
10. The storage system
ADO Series can store two reference waveforms, 20 groups of shots (depending on
memory size oscilloscope decision) to the oscilloscope internal memory.
ADO Series provides USB interface, you can save waveform memory shots to the U disk,
the common image BMP image file can be opened by computer software. In addition, two
sets of waveform parameters are stored and can be produced by "reference waveform"
were transferred out, displayed on the screen.
To save a reference waveform:
1) Main menu, select "Universal oscilloscope" (Automotive Oscilloscope select the
corresponding module), press the "OK" key to enter the user interface
2) Press the "time base", "trigger" or "operator" to any of these options, press "F1" to enter
the reference waveform
3) press "F2" to select the source, then press the "F2" Reference Waveform (each source
can save two set of reference waveform Ref1, Ref2), press the "F4" key to save the
reference waveform and displayed by pressing the "F2 "button selected as the reference"
NULL "to close the reference waveform
Store pictures steps:
Any Screenshots:
1) Oscilloscope and automotive modules interface, long press "F2" operating status
(battery indicator on the left side) will be blinking green to being shot, wait a few seconds,
the name of the successful bomb box prompts screenshots and screenshots will appear.
2) Multimeter screenshot will be prompted "is being shot", will appear successful bomb
box prompts screenshot success.
3) Other interfaces will be prompted being shot, after a successful theme screenshot
bomb box prompt success.
Note: The screenshot function can save 20 or so maps, depending on memory size of the
decision, if prompted screenshot fails, re-theme look, or not, then you see the next
memory to delete a few pictures.
View storage oscilloscope image method:
1) First off the oscilloscope, and then use the data cable to connect the oscilloscope and
the computer, and then press the "F3" key and the "on / off" button until the screen to let
go when the light; this time, the computer will prompt U disk insert, open U disk to see the
pictures taken. After the operation, you must first click Exit U disk mode on the computer,
then disconnect the cable, press the power button to reboot to use it again.
2) to enter the main menu, select the screenshot function, go to theme preview feature to
view screenshots. After the arrow keys can be selected theme, select press "OK" button to
view, press any key to return to the list of shots, "F3" key means to delete the currently
selected theme, "F4" button to remove all screenshots.
31
Advertisement
Table of Contents
