Bus - Jinhan ADO102 Manual

5. Bus

1）CAN-high、CAN-low
①After the oscilloscope installed batteries，long press red power
button" ", let it go until you hear the buzzer，at this time
oscilloscope enter the main menu interface，as picture-1
②After entering the main menu interface select "Bus"， then enter
the sub-menu press the up and down keys to select " CAN-high、
CAN-low "，press "OK" button, after confirmation,
entering oscilloscope operation interface, as picture -2
③Connect the two probes to CH1 and CH2, probe set to 1X ， then connect
grounding chipotle signal ground or grounding
④Since the "CAN-high、CAN-low" function of oscilloscope has
default settings （CH1,CH2:Probe 1X，time base 25us）,simply
connect the probe to the corresponding signal can display
waveform, as picture 14
⑤Press"CH1" and "CH2"，can view the values and configuration
（configuration has default）
⑥Waveform display can be adjusted based on their own through
the vertical volts / division and trigger ways to meet your needs
（Time base, vertical volts / division and other specific operations, please refer to the
operation of general oscilloscope）
CAN-high
CAN-low
Pic-14 CAN-high, CAN-low
Picture-1
Picture-2
22