Jinhan ADO102 Manual page 14

⑥Waveform display can be adjusted based on their own through the vertical
volts / division and trigger ways to meet your needs（Time base, vertical volts /
division and other specific operations, please refer to the operation of general
oscilloscope）
arcing or burning
voltage
2）Secondary ignition
①Same as Primary ignition step 1
②After entering the main menu select "Ignition"，then enter the sub-menu press
the up and down keys to select "secondary ignition"，It will prompt "use
professional ignition probe" before entering the operating interface, wait a few
seconds to enter the oscilloscope interface.
③Independent ignition to be equipped with an ignition extension cord and high
voltage ignition probe must ignition sensing probe, connect ignition probe to
CH1.
④Since the secondary ignition of oscilloscope has default settings（Probe 10X，
time base 1ms）ignition system with sub-cylinder line, probe with capacitor
(small black squares )side is sandwiched with sub-cylinder line, the other side
connected to the ground or battery negative. If the car is an independent
ignition system，you need to buy "independent ignition extension cord"（one
side connect to ignition coil, one side connect to spark plug, the role is to
replace the sub-cylinder line）ignition probe in independent ignition extension
cord, Step as above.
⑤Same as Primary ignition step 5
⑥Same as Primary ignition step 6
3）Primary and secondary ignition
This function let the primary ignition, secondary ignition be realized through CH1
and CH2，observed and compared two waveforms more intuitively. Select"
Primary ignition, secondary ignition" Before entering into operation interface, it
Ignition coil begins
charging
Pic-1 Primary ignition
Breakdown
or ignition voltage
peak
Burn line
Oscillation coil
voltage
11