The Function Of Actuator - Jinhan ADO102 Manual

already default settings (profiles probe 1X, time base range 500us),Just probe to the
corresponding signal and then use a small stick percussion cylinder, To intuitive display
waveforms, as shown in Figure 10. (note: As in the "scan" scan mode requires patience
waveform scanned)
⑤Press "CH1", you can view the value and configuration (by default)
⑥waveform can be self-fulfilling their needs by adjusting the time base, vertical volts /
division and trigger mode (time base, vertical volts / division and other specific operations,
please refer to the Universal oscilloscope operation).
8) Accelerator pedal
①The same as the crankshaft, camshaft position sensor Step 1.
②Select "Sensor" after entering the main menu, then enter the sub-menu press the arrow
keys to select "accelerator pedal" ,press "OK" button to confirm to enter the oscilloscope
user interface .
③Connect the CH1 probe to the oscilloscope and set
probe to 1X file transfer, then connect the grounding clip to
the signal ground or grounding.
④Since the oscilloscope "accelerator pedal" function has
already default settings (profiles probe 1X, time base
range 250ms), just probe to the corresponding signal, to
intuitive display waveforms, as shown in Figure 11. (Note:
As in the "SCAN" scan mode requires patience waveform
scanned)
⑤Press "CH1", you can view the value and configuration
(by default)
⑥waveform can be self-fulfilling their needs by adjusting
the time base, vertical volts / division and trigger mode (time base, vertical volts / division
and other specific operations, please refer to the Universal oscilloscope operation).

4. The Function of Actuator

1）Electromagnetic valve
①After the oscilloscope installed batteries，long press red power
button" "， let
oscilloscope enter the main menu interface， as picture-1
②After entering the main menu interface select "Actuator"， then
enter the sub-menu press the up and down keys to select "
Electromagnetic valve "，press "OK" button, after confirmation, entering oscilloscope
operation interface, as picture -2
③Connect the probe to CH1 and probe set to 1X，then connect
grounding clip to the signal ground or grounding.
④Since the "Electromagnetic valve" Function of oscilloscope has
default settings （Probe 1X，time base 25ms）,simply connect the probe
to the corresponding signal can display waveform. As
it go until you hear the buzzer，at this time
Pic-11 Accelerator
picture-12
Picture-2
Picture-1
19