Universal Oscilloscope This Section Features Are Described - Jinhan ADO102 Manual

2) LIN-bus
①Same as CAN-high、CAN-low step 1
②After entering the main menu interface select "Bus"， then enter the sub-menu press
the up and down keys to select " LIN-bus "，press "OK" button, after confirmation,
entering oscilloscope operation interface
③Connect the probe to CH1 and probe set to 1X，then connect grounding clip to the
signal ground or grounding
④Since the "LIN-bus" Function of oscilloscope has default settings （CH1:Probe 1X，
time base 500us）,simply connect the probe to the corresponding signal can display
waveform.
⑤Press"CH1" and "CH2"，can view the values and configuration（configuration has
default）
⑥Waveform display can be adjusted based on their own through the vertical volts /
division and trigger ways to meet your needs（Time base, vertical volts / division and
other specific operations, please refer to the operation of general oscilloscope）
3) FlexRay
①Same as CAN-high、CAN-low step 1
②After entering the main menu interface select "Bus"， then enter the sub-menu press
the up and down keys to select " FlexRay "，press "OK" button, after confirmation,
entering oscilloscope operation interface
③Connect the two probes to CH1 and CH2, probe set to 1X ， then connect
grounding clip to the signal ground or grounding
④Since the "FlexRay" Function of oscilloscope has default settings （CH1,CH2:Probe
1X， time base 10us） ,simply connect the probe to the corresponding signal can display
waveform.
⑤Press"CH1" and "CH2"，can view the values and configuration（configuration has
default）
⑥Waveform display can be adjusted based on their own through the vertical volts /
division and trigger ways to meet your needs（Time base, vertical volts / division and
other specific operations, please refer to the operation of general oscilloscope

2.2 Universal Oscilloscope this section features are described

Below:
▲ Menus and control systems
▲ Connector
▲ automatically set
▲ The default setting
▲ Vertical System
▲ Horizontal System
▲ Trigger system
▲ Math system
▲ System Settings
▲ Storage System
23