Table of Contents
Advertisement
Auto
Trigger mode
Normal
Single
Instructions:
Set the source:
1).Main menu, select "Universal oscilloscope" press "OK" button to enter the oscilloscope
screen. Press the "TRIG" button to display the trigger menu, according to the signal input,
press the "F3" key to select CH1-CH4.
2).Press "CH1", then press"
press"
""
"or" ""
voltage value represents the relative position and the current channel a flag vertically to
set the trigger level size.
Set slope:
3).Press the "F2" key to select slope "up" or "down."
Set trigger mode:
4).Press the "F4" key to select "Auto", "normal" or "single."
Auto: Set in the absence of detectable also can collect waveform trigger conditions
Normal: Set only a triggering condition is satisfied only waveform
waveform when a trigger is detected, then stop As Figure 2-11
8. Math System
Math function is to display CH1, CH2, CH3, CH4 two two-channel waveform additions,
subtraction functions
Table 2-4 Math Functions
Menu
Settings
Comments
Arithmetic
Functions
Source A
Settings
CH1-CH4
Set in the absence of detectable also can collect waveform trigger
conditions
condition is satisfied only waveform
Set capture a waveform when a trigger is detected, then stop
"or"
"adjusts channel 1 mark. Press the "TRIG", then
"adjust the trigger flag arrow, According trigger flag each cell
Figure 2-11
Setting
/
Set CH1, CH2, CH3, CH4 as source B
Source
Single: Set capture a
Description
Set only a triggering
29
Advertisement
Table of Contents
