Jinhan ADO102 Manual page 36

Measure Method:
Table2-7 Multimeter Operation Key Function
Key
Multimeter Press this key to enter Multimeter Mode.
Press "
Press "
Multimeter's RUN/HOLD key.
Note 1: Multimeter's default range is "Auto" position, for manually setting the
range, first predicted your Measurements..
Note 2: Display screen show flashing "
running;" MANU" means manually set the range.
⒈ DC and AC Voltage measuring
① The Black Pen connect to the COM interface on the top of the device(the
black interface),and the Red Pen connect to VΩ interface(the red
interface)
② Press "ON/OFF" key until the system is started, then press "Multimeter"
key to switch to Multimeter Function.
Press " " or "
③
Voltage" has a Shortcut,"F1".
④ Connect the test pen to the measured voltage, the device will read the
value and show on the screen (it can also read negative value.).AC Voltage
has no polarity. This device's default Range is "Auto", you can press "
" " to change the Range.
⒉ Resistance measuring
① Press " " or "
② Put the pen on the two side of the resistor, device can read it's value.
Maybe you should set the Range manually.
⒊ Capacitance measuring
① Press " " or "
② put the pen on the two side of the capacitance, device can read it's value.
Note: Capacitance measuring can't set Range.
⒋ Diode and Buzzer-off measuring
① Press " " or "
measuring has a shortcut ,"F3".
② Put the pen on the two side of the Diode or the line, device can read it's value.(The
value when measuring diode, it's diode Conduction voltage drop)
③ When mesuareing resistance is below 60Ω, buzzer alams.
Attention:
a. The device has forward and reverse voltae, when the diode connected reversed, the
value is negative.
" or " " to select Mesure Type
" or " " to tune the Range
" to select "DC voltage" or "AC Voltage" measuring."DC
" to select Resistance mesuare.it has a shortcut,"F2".
" to select Capacitance mesuare.
" key to select "Diode" or "Buzzer-off" measuring. Buzzer-off
Description
"means Multimeter is
" or
33