Backing Up The Configuration - IBM Brocade FCoE Installation And User Manual

4. Type conf t and press Enter.
5. Type int int (press tab to complete the second int) 0/x where x is the internal port you wish to
6. Once in the particular interface type fcoeport and press Enter.
7.
8. Type exit and press Enter.
9. Repeat steps 5-8 for any other blade port you wish to configure.
10. Once finished with all of the blade ports, type exit and press Enter (you should still be in the
11. Type write mem and press Enter.
12. Type copy run start and press Enter.
See the Converged Enhanced Ethernet Administrator's Guide for information about CEE CLI
interface and configuring switches for FCoE operation and the Converged Enhanced Ethernet
Command Reference for more details on the commands.

Backing up the configuration

Perform these steps to back up the switch module configuration to an FTP server.
1. Open a Telnet or SSH session to the switch module.
2. Enter configUpload.
3. Follow the prompts to upload the configuration.
This command uploads the switch module configuration to the server, making it available for
downloading to a replacement switch module if necessary.
Brocade recommends backing up the configuration on a regular basis to ensure that a complete
configuration is available for downloading to a replacement switch module.
For specific instructions about how to back up the configuration, refer to the Fabric OS
Administrator's Guide. The switchShow, fabricShow, and configUpload commands are described in
detail in the Fabric OS Command Reference.
change and press Enter.
Type no shut and press Enter.
CMSH at this point).
Answer yes to overwrite the startup file.
Answer yes to overwrite.
You are then presented with a series of prompts.
Chapter 6. Configuring the switch module
33