Getting Started; Introduction; Related Documentation; Step 1. Unpack And Inspect The P937Xa Network Analyzer - Keysight Streamline Series Startup Manual

Keysight Streamline Vector Network Analyzers
P937xA
Startup Guide
1

Getting Started

Introduction

The scope of this Startup Guide is to detail the processes of receiving and installing the
Keysight Streamline Series P937xA vector network analyzer (VNA) and cables that
compose the P937xA VNA. Additionally, installing the required software and verifying
P937xA vector network analyzer operation is documented. If you have any questions
after reviewing this information, please contact your local Keysight Technologies Inc.
representative or contact us through our support Website at
http://www.keysight.com/technicalsupport/main.

Related Documentation

You can find all P937xA network analyzer documentation and other resources
at
on

STEP 1. Unpack and Inspect the P937xA Network Analyzer

Most causes of instrument failure can be avoided if you will apply the
information in this section. PLEASE READ!
Electrostatic discharge (ESD) can damage or destroy electronic components.
Use a static-safe work station to perform all work on electronic assemblies.
Figure 1-1 on page 6
protection: conductive table-mat and wrist-strap combination, and conductive
floor-mat and heel-strap combination. Both types, when used together,
provide a significant level of ESD protection. Of the two, only the table-mat and
wrist-strap combination provides adequate ESD protection when used alone.
To ensure user safety, the static-safe accessories must provide at least 1
meg-ohm of isolation from ground.
Do NOT use these techniques for a static-safe work station when
working on circuitry with a voltage potential greater than 500 volts.
https://www.keysight.com/find/usb-vna
www.keysight.com (go to Resource Center > Manuals).
shows a static-safe work station using two types of ESD
or at the respective product pages
1-5