Power Up The Instrument With A Pc - Keysight Streamline Series Startup Manual

Getting Started
STEP 3. Install the Software
e. Power up the remote controller PC.
Check for software updates at:
http://www.keysight.com/technicalsupport/main. Enter the model for your
instrument and click Find. Follow the installer prompts.

Power Up the Instrument with a PC

IMPORTANT! Before connecting your P937xA to your PC, ensure that your
PC has the Keysight IO Libraries Suite (IOLS 2018 Update 1 or greater) and
the P937xA firmware loaded. If not, refer to
Overview" on page
The following assumes you have previously loaded your firmware and IO
Libraries (IOLS 2018 Update 1 or greater
"Software Installation Overview" on page
If you have loaded the IO Libraries (IOLS 2018 Update 1 or greater) and the
P937xA firmware, complete the following steps:
STOP! If you have not installed the firmware and the IO Libraries (IOLS
2018 Update 1 or greater) into the PC controller, refer to
Installation Overview" on page
Before powering up the P937xA, ensure that the DC power connector is
securely seated.
Before powering up the P937xA, ensure the P937xA "USB 3.0 to host PC"
cable interface is connected to the PC controller. After your P937xA has
been initialized, you can disconnect and reconnect the USB cable per a
typical USB device's behavior.
1. Install the cable interface between the PC and the chassis.
2. Power up the P937xA instrument.
3. Power up the PC.
4. Start the P937xA application software.
If your P937xA application software and P937xA does not behave as
expected with the newly installed IO Libraries and firmware, cycle power
on the P937xA.
1. IO Libraries version 2018 update 1, version 18.1.23205.4 or greater. BenchVue and
Connection Expert are optional downloads.
1-10
9.
1
) onto your PC. If not, refer to the
9.
9.
Keysight Technologies Startup Guide
"Software Installation
"Software