Table of Contents
Advertisement
12.0 - REMOTE CONTROL
The remote control has 2 different function buttons each of which corresponds
to a control signal that activates a selected action according to the operational
condition and alarm configuration.
The textured button is for arming/disarming the alarm while the smooth button
is used to exclude or trigger the siren.
• Arm/disarm alarm unit
Button 1
:
Button
2:
• Trigger/Stop p
anic
alarm
• Exclude siren (mute alarm)
• Activate Hazard lights
The remote control has a low charge battery indicator that gives you early
warning to avoid malfunctioning. When the batteries are fully charged, the LED
will show a steady light at the press of a button. If the batteries are too weak for
normal operation, the LED will start blinking at the press of a button. To replace
the batteries proceed as follows:
BATTERIES
Remove the
Separate the shell
discharged batteries
halves taking care
and insert the new
not to damage the
ones taking care not to
internal circuit.
invert the polarity.
WARNING
!
U
se only CR1616 batteries.
Different type batteries can seriously damage the remote control unit.
Discard used batteries properly in special dedicated containers
PAGE16
13.0 - WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT
The present device falls within the field of application of the current WEEE
Directive. The crossed-out wheeled bin symbol on the equipment or on its
packaging indicates that the product, at the end of its useful life, must be
discarded separately from other waste to allow adequate treatment and
recycling.
The user must therefore take the equipment, at the end of its useful life, to an
appropriate waste collection facility.
LED
indicator
Button 1
Button 2
Close the plastic
shells and make
sure the remote
works properly.
.
14.0 - TECHNICAL SPECIFICATIONS
Nominal supply voltage
< 1mA (alarm armed and LED flashing)
Load @ 12Vdc
Load in sleep mode
Siren output level
Relay capacity
12 Vdc
< 1µA
118 dBA @ 1 meter
8A
PAGE17
Advertisement
Table of Contents
