Table of Contents
Advertisement
3.0 - ACCESSORIES POSITIONING
3.1 - Override key receptacle
The receptacle with built-in LED must be installed where it can readily be seen
and accessed by the user. Before drilling a hole in the plastic dash with a 13mm
drill bit, check the position of the handlebars with the steering lock engaged.
Make sure the LED will not be covered by the handlebars when the vehicle is
parked.
Override key
Example of receptacle positioning on the vehicle
plastic side cover
3.2 - Contact switch (optional)
A contact switch can be fitted to protect the seat or topcase. It must be installed
in such a way as to detect the opening of the seat/topcase without being
accessible from the outside. The trigger threshold must be carefully set to
avoid false alarms.
Do not ground the switch terminal to the vehicle frame make a connection to
earth through a negative cable such as the indicator lamp negative lead.
NB:
If no contact switch is fitted, the GREEN/BROWN wire will remain free for
other possible uses such as programming the alarm or learning new devices.
PAGE 4
To seal the alarm, position the
rubber cap over the external edge
Pull the plastic rectangular flange
over the rubber cap and secure
Override
key
4.0 - ALARM UNIT SEALING
of the alarm housing.
with the supplied screws.
Do not over tighten.
Alarm unit sealed
PAGE 5
Advertisement
Table of Contents
