Meaning Of The Leds On The Control Interface Board In The Basic Line Module - Siemens SINAMICS S120 Equipment Manual

3.2.3.8

Meaning of the LEDs on the Control Interface Board in the Basic Line Module

Table 3- 6 Meaning of the LEDs on the Control Interface Board in the Basic Line Module
LED state
H200 H201
Off Off
Green Off
Orange
Red
Orange Orange
Red ---
Flashing light ---
0.5 Hz:
Green / red
2 Hz flashing: ---
Green / red
2 Hz flashing: ---
Green /
orange
or
red / orange
Irrespective of the state of LED "H201", hazardous DC link voltage can always be present.
The warning information on the component must be carefully observed!
Chassis power units
Manual, (GH3), 10/2008, 6SL3097-2AE00-0BP3
Description
The electronics power supply is missing or out of tolerance.
The component is ready for operation and cyclic DRIVE-CLiQ communication is taking place.
The component is ready for operation and cyclic DRIVE-CLiQ communication is taking place.
The DC link voltage is present.
The component is ready for operation and cyclic DRIVE-CLiQ communication is taking place.
The DC link voltage is too high.
DRIVE-CLiQ communication is being established.
At least one fault is present in this component.
Note:
LED is driven irrespective of the corresponding messages being reconfigured.
Firmware is being downloaded.
Firmware download is complete. Waiting for POWER ON.
Component detection using LED is activated (p0124)
Note:
The two options depend on the LED status when module recognition is activated via
p0124 = 1.
WARNING
Line Modules
3.2 Basic Line Modules
79