Assembly Instruction - HMS BE4800-i Manual Instruction

Assembly Instruction

Please make sure there's enough space to install the treadmill and recommend 2 persons to install it.
WARNING: Don't insert the power wire until the treadmill was fully assembled.
3. Assembling left upright tube and Base frame
Insert Left upright tube (4) to base frame (13), and attach four half-round bolts
M8X16 (A2), one Half-round bolt M8X40 (A1), and five Flat washers Φ8 (C1), Do
not tighten all parts provisionally (see figure 1)
4. Assembling right upright tube and Base frame
a. Pull out the Signal wire (49) from the lower side to upper side of the right
upright tube(5). (see figure 2)
b. Insert Right upright tube (5) to base frame (13), and attach four Half-round bolts
M8X16 (A2), one Half-round bolt M8X40 (A1), and five Flat washers Φ8(C1). Do
not tighten all parts provisionally. (see figure 2)
3. Assembling left and right upright tube with computer / handlebar
a. Connect the Signal wire (49) to corresponding wires that come from
computer/handlebar (10) (see figure 3)
b. Tighten the computer/handlebar (10) to upright tubes (4/5) with six Half-round
bolts M8X16 (A2), six Flat washers Φ8 (C1).
c. Screw up all the bolts of the step 1 and 2.
BE4800-i
24