Figure 157: Configuring LLDP Interface Attributes
Configuring LLDP
Use the Administration > LLDP (Configure Interface – Add CA-Type) page to specify
Interface Civic-
the physical location of the device attached to an interface.
Address
Command Usage
◆
Use the Civic Address type (CA-Type) to advertise the physical location of the
device attached to an interface, including items such as the city, street number,
building and room information. The address location is specified as a type and
value pair, with the civic address type defined in RFC 4776. The following table
describes some of the CA type numbers and provides examples.
Table 22: LLDP MED Location CA Types
CA Type
Description
1
National subdivisions (state, canton, province)
2
County, parish
3
City, township
4
City division, borough, city district
5
Neighborhood, block
6
Group of streets below the neighborhood level
18
Street suffix or type
19
House number
20
House number suffix
– 251 –
Chapter 12
| Basic Administration Protocols
Link Layer Discovery Protocol
CA Value Example
California
Orange
Irvine
West Irvine
Riverside
Exchange
Avenue
320
A