Parkview Rear Back Up Camera - If Equipped - Jeep Grand Cherokee SRT 2019 Owner's Manual

• The system will not apply torque to the steer-
ing wheel whenever a safety system engages
(anti-lock brakes, traction control system,
electronic stability control, forward collision
warning, etc.).
PARKVIEW REAR BACK UP
CAMERA — IF EQUIPPED
The ParkView Rear Back Up Camera allows you
to see an on-screen image of the rear surround-
ings of your vehicle whenever the gear selector
is put into REVERSE. The image will be dis-
played on the Navigation/Multimedia radio dis-
play screen along with a caution note to "check
entire surroundings" across the top of the
screen. After five seconds this note will disap-
pear. The ParkView camera is located on the
rear of the vehicle above the rear license plate.
When the vehicle is shifted out of REVERSE
(with camera delay turned off), the rear camera
mode is exited and the navigation or audio
screen appears again.
Manual Activation Of The Rear View Camera
1. Press the "Controls" button located on the
bottom of the Uconnect display.
2. Press the "Backup Camera" button to turn
the Rear View Camera system on.
NOTE:
The ParkView Rear Back Up Camera has pro-
grammable modes of operation that may be
selected through the Uconnect System.
186
Refer to "Uconnect Settings" in "Multimedia" for
further information.
When the vehicle is shifted out of REVERSE
(with camera delay turned off), the rear camera
mode is exited and the previous screen appears
again. When the vehicle is shifted out of RE-
VERSE (with camera delay turned on), the
camera image will continue to be displayed for
up to ten seconds after shifting out of REVERSE
unless the vehicle speed exceeds 8 mph
(13 km/h), the vehicle is shifted into PARK, the
vehicle's ignition is cycled to the OFF position,
or the user presses image defeat [X] to exit out
of the camera video display.
When enabled, active guide lines are overlaid
on the image to illustrate the width of the vehicle
and its projected backup path based on the
steering wheel position. A dashed center line
overlay indicates the center of the vehicle to
assist with parking or aligning to a hitch/receiver.
Different colored zones indicate the distance to
the rear of the vehicle. The following table
shows the approximate distances for each zone:
Distance To The Rear Of
Zone
The Vehicle
Red 0 - 1 ft (0 - 30 cm)
Yellow 1 ft - 6.5 ft (30 cm - 2 m)
6.5 ft or greater (2 m or
Green
greater)
WARNING!
Drivers must be careful when backing up
even when using the ParkView Rear Back Up
Camera. Always check carefully behind your
vehicle, and be sure to check for pedestrians,
animals, other vehicles, obstructions, or blind
spots before backing up. You are responsible
for the safety of your surroundings and must
continue to pay attention while backing up.
Failure to do so can result in serious injury or
death.
CAUTION!
• To avoid vehicle damage, ParkView should
only be used as a parking aid. The
ParkView camera is unable to view every
obstacle or object in your drive path.
• To avoid vehicle damage, the vehicle must
be driven slowly when using ParkView to
be able to stop in time when an obstacle is
seen. It is recommended that the driver
look frequently over his/her shoulder when
using ParkView.
NOTE:
If snow, ice, mud, or any foreign substance
builds up on the camera lens, clean the lens,
rinse with water, and dry with a soft cloth. Do not
cover the lens.