Jeep Grand Cherokee SRT 2019 Owner's Manual page 236

2. To disengage the wiper blade from the wiper
arm, flip up the release tab on the wiper
blade and while holding the wiper arm with
one hand, slide the wiper blade down to-
wards the base of the wiper arm.
Wiper Blade With Release Tab In Unlocked
Position
1 — Wiper Blade
2 — Release Tab
3 — Wiper Arm
3. With the wiper blade disengaged, remove
the wiper blade from the wiper arm by hold-
ing the wiper arm with one hand and sepa-
rating the wiper blade from the wiper arm
with the other hand (move the wiper blade
toward the right side of the vehicle to sepa-
rate the wiper blade from the wiper arm).
Wiper Blade Removed From Wiper Arm
1 — Wiper Blade
2 — Wiper Arm
3 — Release Tab
4. Gently lower the wiper arm onto the glass.
Installing The Front Wipers
1. Lift the wiper arm off of the glass, until the
wiper arm is in the full up position.
2. Position the wiper blade near the hook on the
tip of the wiper arm with the wiper release tab
open and the blade side of the wiper facing
up and away from the windshield.
3. Insert the hook on the tip of the arm through
the opening in the wiper blade under the
release tab.
4. Slide the wiper blade up into the hook on the
wiper arm and rotate the wiper blade until it is
flush against the wiper arm. Fold down the
latch release tab and snap it into its locked
position. Latch engagement will be accom-
panied by an audible click.
5. Gently lower the wiper blade onto the glass.
Rear Wiper Blade Removal/Installation
1. Lift the rear wiper arm pivot cap away from
the glass to allow the rear wiper blade to be
raised off of the glass.
NOTE:
The rear wiper arm cannot be fully raised off the
glass unless the wiper arm pivot cap is un-
snapped first. Attempting to fully raise the rear
wiper arm without unsnapping the wiper arm
pivot cap may damage the vehicle.
Wiper Pivot Cap In Unlocked Position
1 — Wiper Arm Pivot Cap
2 — Wiper Arm
235