Changing Lanesense Status; Parkview Rear Back Up Camera - If Equipped - Jeep CHEROKEE User Manual

For example: If approaching the left side
of the lane the steering wheel will turn to
the right.
When the LaneSense system senses the

lane has been approached and is in a lane
departure situation, the left thick lane line
flashes yellow (on/off) and the left thin
line remains solid yellow. The LaneSense
telltale changes from solid yellow to
flashing yellow. At this time torque is
applied to the steering wheel in the oppo-
site direction of the lane boundary.
For example: If approaching the left side
of the lane the steering wheel will turn to
the right.
NOTE:
The LaneSense system operates with the
similar behavior for a right lane departure.

Changing LaneSense Status

The LaneSense system has settings to adjust
the intensity of the torque warning and the
warning zone sensitivity (early/late) that you
can configure through the Uconnect system
screen.
Refer to "Uconnect Settings" in "Multi-
media" in the Owner's Manual for further
information.
NOTE:
When enabled, the system operates above

37 mph (60 km/h) and below 112 mph
(180 km/h).
Use of the turn signal suppresses the

warnings.
The system will not apply torque to the

steering wheel whenever a safety system
engages (Anti-Lock Brakes,
Control System, Electronic
Control, Forward Collision Warning, etc.).
PARKVIEW REAR BACK UP
CAMERA — IF EQUIPPED
Your vehicle may be equipped with the
ParkView Rear Back Up Camera that allows
you to see an on-screen image of the rear
surroundings of your vehicle whenever the
gear selector is put into REVERSE. The
image will be displayed in the touchscreen
display along with a caution note to "check
entire surroundings" across the top of the
screen. After five seconds this note will
disappear. The ParkView camera is located
on the rear of the vehicle above the rear
license plate.
NOTE:
The ParkView Rear Back Up Camera has
programmable modes of operation that may
be selected through the Uconnect System.
Refer to "Uconnect Settings" in "Multi-
media" in the Owner's Manual for further
information.
WARNING!
Traction
Drivers must be careful when backing up
Stability
even when using the ParkView Rear Back
Up Camera. Always check carefully behind
your vehicle, and be sure to check for
pedestrians, animals,
obstructions, or blind spots before backing
up. You are responsible for the safety of
your surroundings and must continue to
pay attention while backing up. Failure to
do so can result in serious injury or death.
CAUTION!
To avoid vehicle damage, ParkView

should only be used as a parking aid. The
ParkView camera is unable to view every
obstacle or object in your drive path.
other vehicles,
(Continued)
171