Enabling And Disabling The Parksense Active Park Assist System - Jeep Grand Cherokee SRT 2019 Owner's Manual

rain, snow, etc., or if searching for a parking
space that has surfaces that will absorb the
ultrasonic sensor waves).
• New vehicles from the dealership must have
at least 30 miles (48 km) accumulated before
the ParkSense Active Park Assist system is
fully calibrated and performs accurately. This
is due to the system's dynamic vehicle cali-
bration to improve the performance of the
feature. The system will also continuously
perform the dynamic vehicle calibration to
account for differences such as over or under
inflated tires and new tires.
Enabling And Disabling The
ParkSense Active Park Assist
System
The ParkSense Active Park Assist
system can be enabled and dis-
abled with the ParkSense Active
Park Assist switch, located on the
switch panel below the Uconnect
display.
To enable the ParkSense Active Park Assist
system, push the ParkSense Active Park Assist
switch once (LED turns on).
To disable the ParkSense Active Park Assist
system, push the ParkSense Active Park Assist
switch again (LED turns off).
The ParkSense Active Park Assist system will
turn off automatically for any of the following
conditions:
• The parking maneuver is completed.
• Vehicle speed greater than 18 mph (30 km/h)
when searching for a parking space.
• Vehicle speed greater than 5 mph (7 km/h)
during active steering guidance into the park-
ing space.
• Touching the steering wheel during active
steering guidance into the parking space.
• Pushing the ParkSense Front and Rear Park
Assist switch.
• Driver's door is opened.
• Rear liftgate is opened.
• Electronic Stability Control/Anti-lock Braking
System intervention.
• The ParkSense Active Park Assist system will
allow a maximum of six shifts between
DRIVE and REVERSE. If the maneuver can-
not be completed within six shifts, the system
will cancel and the instrument cluster display
will instruct the driver to complete the maneu-
ver manually.
The ParkSense Active Park Assist system will
only operate and search for a parking space
when the following conditions are present:
• Gear position is in DRIVE.
• Ignition is in the RUN position.
• ParkSense Active Park Assist switch is
activated.
• Driver's door is closed.
• Rear liftgate is closed.
• Vehicle speed is less than 15 mph (25 km/h).
NOTE:
If the vehicle is driven above approximately
15 mph (25 km/h), the instrument cluster display
will instruct the driver to slow down. If the vehicle
is driven above approximately
(30 km/h), the system will cancel. The driver
must then reactivate the system by pushing the
ParkSense Active Park Assist switch.
• The outer surface and the underside of the
front and rear fascias/bumpers are clean and
clear of snow, ice, mud, dirt or other
obstruction.
When pushed, the LED on the ParkSense Ac-
tive Park Assist switch will blink momentarily,
and then the LED will turn off if any of the above
conditions are not present.
18 mph
175