Body Lubrication - Jeep Grand Cherokee SRT 2019 Owner's Manual

NOTE:
When disengaging the glove compartment door
from its hinges, there will be some resistance.
4. With the glove compartment door loose, re-
move the glove compartment tension tether
and tether clip by sliding the clip toward the
face of the glove compartment door and
lifting the clip out of glove compartment door.
Right Side Of Glove Compartment
1 — Glove Compartment Tension Tether
2 — Glove Compartment Door
5. Remove the filter cover by disengaging the
retaining tab and mid way snap that secures
the filter cover to the HVAC housing. Disen-
gage the mid way snap by pulling the door
outward. Unhinge the filter cover on the right
side to fully remove the cover.
A/C Air Filter Cover
1 — Retaining Tab
2 — Mid Way Snap
3 — Filter Cover Hinge
6. Remove the A/C air filter by pulling it straight
out of the housing.
7. Install the A/C air filter with the arrow on the
filter pointing toward the floor. When install-
ing the filter cover, make sure the retaining
tabs fully engage the cover.
CAUTION!
The cabin air filter is identified with an arrow
to indicate airflow direction through the filter.
Failure to properly install the filter will result in
the need to replace it more often.
8. Reinstall the glove compartment door on the
door hinge and reattach the tension tether by
inserting the tether clip in the glove compart-
ment and sliding the clip away from the face
of the glove compartment door.
9. Push the door to the near closed position to
reengage the glove compartment travel
stops.
NOTE:
Ensure the glove compartment door hinges and
glove compartment travel stops are fully en-
gaged.

Body Lubrication

Locks and all body pivot points, including such
items as seat tracks, door hinge pivot points and
rollers, liftgate, tailgate, decklid, sliding doors
and hood hinges, should be lubricated periodi-
cally with a lithium based grease, such as Mopar
Spray White Lube to assure quiet, easy opera-
tion and to protect against rust and wear. Prior to
the application of any lubricant, the parts con-
cerned should be wiped clean to remove dust
and grit; after lubricating excess oil and grease
should be removed. Particular attention should
also be given to hood latching components to
ensure proper function. When performing other
233