Battery Saver On/Battery Saver Mode Message - Electrical Load Reduction Actions - If Equipped - Jeep Grand Cherokee SRT 2019 Owner's Manual

• Trip Info (show/hide)
• Audio (show/hide)
• Messages
• Screen Setup
• Diagnostic Codes
• Speed Warning (Show/Hide)
The menu with (show/hide) means user can
press OK button to choose show or hide this
menu on the instrument cluster display.
Diagnostics
Push and release the up or down arrow button
until the Diagnostics icon/title is highlighted in
the instrument cluster display. Push and release
the OK button to display the diagnostic trouble
codes and descriptions. When the end of the list
is reached, "No or End of Diagnostic Code" will
appear in the instrument cluster display.
Speed Warning
Push and release the up or down arrow button
until the Speed Warning Menu icon/title is dis-
played in the instrument cluster display. Push
and release OK to enter speed warning. Use the
up or down arrow button to select a desired
speed, then push and release OK to set the
speed. The white passive speed limiter telltale
will light up with a notification text message
(Speed Warning Set to XX, followed by the
selected unit). When the set speed is exceeded,
an audible chime will sound for up to 10 seconds
or until the speed is no longer exceeded. The
white passive speed limiter telltale will turn
yellow and will flash, and a pop up message of
"Speed Warning Exceeded" will display.
NOTE:
You can turn the Speed Warning off by using the
up/down arrows to scroll through speed list and
select OFF at the bottom of the list.
Battery Saver On/Battery Saver
Mode Message — Electrical Load
Reduction Actions — If Equipped
This vehicle is equipped with an Intelligent Bat-
tery Sensor (IBS) to perform additional monitor-
ing of the electrical system and status of the
vehicle battery.
In cases when the IBS detects charging system
failure, or the vehicle battery conditions are
deteriorating, electrical load reduction actions
will take place to extend the driving time and
distance of the vehicle. This is done by reducing
power to or turning off non-essential electrical
loads.
Load reduction is only active when the engine is
running. It will display a message if there is a
risk of battery depletion to the point where the
vehicle may stall due to lack of electrical supply,
or will not restart after the current drive cycle.
When load reduction is activated, the message
"Battery Saver On" or "Battery Saver Mode" will
appear in the instrument cluster display.
These messages indicate the vehicle battery
has a low state of charge and continues to lose
electrical charge at a rate that the charging
system cannot sustain.
NOTE:
• The charging system is independent from
load reduction. The charging system per-
forms a diagnostic on the charging system
continuously.
• If the Battery Charge Warning Light is on it
may indicate a problem with the charging
system. Refer to "Battery Charge Warning
Light" in "Warning Lights And Messages"
located in "Getting To Know Your Instrument
Panel" for further information.
The electrical loads that may be switched off (if
equipped), and vehicle functions which can be
effected by load reduction:
• Heated Seat/Vented Seats/Heated Wheel
• Rear Defroster And Heated Mirrors
• HVAC System
• Audio and Telematics System
Loss of the battery charge may indicate one or
more of the following conditions:
• The charging system cannot deliver enough
electrical power to the vehicle system be-
cause the electrical loads are larger than the
capability of charging system. The charging
system is still functioning properly.
77