Installing Signal Booster - SureCall Force5 Inline User Manual

Step 2. Install the Signal Booster
1. Select a location for your booster close to a working AC outlet. Do not expose the signal
booster to excessive heat, direct sunlight, moisture, and airtight enclosures.
2. Attach the supplied mounting kit to the booster using the supplied screws. Tighten the
screws with a screwdriver until snug, then add a 1⁄4-to-1/2 turn. Do not over tighten.
3. Orient the signal booster so the LEDs and DIP switches face away from the wall and
the LEDs are seen easily. Then mount the signal booster to the wall using appropriate
screws and/or wall anchors.
4. Connect the main cable line from the primary booster to the booster's connector labeled
"Outside". Hand-tighten the connection.
5. Connect the inside antenna cable to signal booster marked INSIDE. Hand-tighten the
connection.
6. Connect the AC power cord to the signal booster.
7. Connect the plug on the other end of the 110V AC power outlet.
8. Turn the booster's power switch on.
• The signal booster turns on automatically.
• The Power LED lights up to show that the signal booster is ready for use.
• The Alert LEDs flash up to 15 seconds on each band to show the band is activated.
Note: If the Power LED does not turn ON or the Alert LEDs continue to flash, see Troubleshooting page 19. This booster is rated for 19V AV input
voltage. DO NOT use the booster with a higher voltage power supply. This can damage the booster, cause persoanl injury and viod your warrenty.
SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | sales@surecall.com
Installing Your Hardware
7