Table of Contents
Advertisement
HC 402 • Setup Guide (Continued)
Using the OSD menu to configure the AV settings
•
Use the Quick Setup submenu to set input EDID settings, set output resolution, mute audio, activate video test patterns,
enable or disable DHCP, and set the IP address.
Use the Picture Controls submenu to view the image position and size.
•
•
Use the Input submenu to set the input format for digital inputs, set horizontal and vertical start values, set the total pixels
and phase, set HDCP authorization, and set the EDID for the current input.
•
Use the Output submenu to set output resolution, HDMI output format, and HDCP notification.
Use the Audio submenu to mute audio, set the audio input format (see table below) for the selected input, set program audio
•
volume, and set audio output format (stereo, mono).
Audio Input Format
None
Analog
LPCM-2Ch
Multi-Ch
LPCM-2Ch auto
Multi-Ch auto
•
Use the Advanced submenu to select a test pattern, set the screen saver, set the aspect ratio, configure auto switching, and
reset the device to factory defaults.
•
Use the Communication submenu to view the device MAC address, DHCP status, the current IP address and subnet mask,
and gateway.
NOTE:
Press and hold the Enter button for 10 seconds to edit settings in the Communication submenu.
•
Use the Device Info screen to view the device name, firmware build, temperature, input and output information, and
detected display. This screen is read-only.
See the HC 400 Series User Guide for details about the menus and available settings, and for a list of output scaler rates.
Step 7 — Configure the Control Settings
To use the COM, IR, or digital I/O ports on the receiver, you must configure them. Also, CEC control of the output device can be
customized during configuration with Global Configurator.
The basic steps are outlined below in the recommended order.
NOTE:
See the Toolbelt Help File or Global Configurator Help File, and GUI Designer Help File as needed for step-by-step
instructions and detailed information. The help file for GC includes an introduction to the software and how to start a project
and configuration.
Using GC, create a new GC Pro or GC Plus project and configure the receiver and other IP Link Pro devices. The
1.
configuration tells the receiver:
•
how its control ports function
•
how to control other products
•
which touchpanels to interact with
Configure the control ports on the receiver.
a.
Select device drivers and link them to each serial, IR, or Ethernet port.
•
Select settings (serial protocol or digital I/O settings) as needed.
•
Configure CEC controls, if desired
•
Set up monitors, schedules, macros, timers, and local variables.
b.
Add any optional touchpanels and set them up:
c.
Create the GUI configuration for the touchpanels and add it to the project.
•
Program functions, monitors, or schedules to the touchpanels and their buttons.
•
Save and build the project.
2.
Upload the system configuration to the HCR 102 receiver.
3.
8
Details
Mutes all audio for selected input. Sets "No Audio" EDID.
Sets the selected input to analog (default for input 1). Sets "No Audio" EDID.
Sets the selected input to LPCM-2Ch digital audio (default for input 2). Sets 2Ch audio EDID.
Sets the selected input to Multi-Ch digital audio. Sets Multi-Ch audio EDID.
Sets the selected input to prioritize digital audio (default for inputs 3-4). Analog audio is passed when
digital audio is not present. Sets 2Ch audio EDID.
Sets the selected input to prioritize digital audio. Analog audio is passed when digital audio is not
present. Sets Multi-Ch audio EDID.
•
what to monitor
•
when to do things
•
whom to notify, how, and under what circumstances
Advertisement
Table of Contents
