Panels And Features; Front Panel Features - Extron electronics HC 402 Setup Manual

HC 402 • Setup Guide (Continued)

Panels and Features

Front Panel Features

HCR 102
INPUT
R
CONFIG
I J A B
HCR 102 Front Panel (Above),
Figure 2.
HCT 101 D Front Panel Without Wallplate (Right)
A
Configuration (Config) connector (USB mini-B), page 11
B
Input selection button and
C
Input signal presence (Signal)
D
HDCP status LED, page 13
E
Audio input type LEDs
F
Menu button,
G
Enter button, and
H
Navigation (right , left , up , and down  arrow) buttons (see
the AV settings using the OSD and front panel buttons:
I
Power LED (HCT 101 D), power and reset indicator LED (HCR 102) —
This green LED indicates either the power status of the HCT 101 D transmitter or
the HCR 102 receiver, or the reset mode of the receiver. For LED indications, see
the table below.
J
Reset button (HCR 102) — Pressing this recessed button causes various product
settings to be reset to the factory defaults (see
page 15).
I
Reset and power LED (
HCT 101 D Transmitter
• Off — The unit is not powered on.
• On, lit amber — The unit is powered on
but there is no active signal at that input.
On, lit green — The unit is powered on
•
and there is an active signal at that input.
2
C
1
SIGNAL
1
HDCP
D
LED, page 13
LED, page 13
(LPCM-2Ch and Multi-Ch, page 14)
Reset Modes: a Brief Summary
) indications are as follows:
HCR 102 Receiver
• Off — The unit is not powered on.
• On, lit steadily — The unit is powered on.
• Blinking — The unit is powering up or the HCR 102 is performing a reset.
The blink pattern depends on the selected reset mode.
For full descriptions of reset modes, how to use the reset button to activate
them, and details of LED indications of each mode, see the HC 400 Series
User Guide.
MENU HOLD FOR 720p/1080p
AUDIO
LPCM-2CH
MULTI-CH
ENTER
E FG H
To configure
on page 7)
on
HCR 102
I
AUDIO IN
HDMI IN
Input
2
e
HCT 101 D Front
(Without Wallplate)
NOTE:
For other
connectors on the
HCT 101 D, see Rear
and Side Panel
Features
on page 3.