Table of Contents
Advertisement
To configure network settings using Toolbelt:
Connect the PC that you will use for setup and the HCR 102 receiver to the same network, and apply power to all devices.
1.
For details on the LAN connection, see
Start Toolbelt.
2.
Start device discovery from within Toolbelt. Toolbelt displays a list of all Extron control devices connected to the network.
3.
In Toolbelt, use the MAC address to locate the desired device (the HCR 102) in the list and select it.
4.
Use the Set IP feature in Toolbelt or use the Toolbelt Manage > Network Settings tab feature to enter the IP address and
5.
subnet address, then configure other network settings as needed.
NOTE:
When setting up DHCP during network configuration or if using a host name instead of an IP address, the user
must enter a qualified host name (Username.HostName.Domain). For example: somename.extron.com.
Step 6 — Configure AV Settings
The AV and scaling settings for the system can be configured via a host connection through the LAN port or the USB port using
PCS software or the on-screen display. Many settings can be configured using either method (OSD or PCS). Some settings are
available only in the PCS software.
To configure the AV settings using PCS software:
Install Extron PCS (Product Configuration Software) on a PC and start the program.
1.
Connect the PC to the receiver via the rear panel LAN port (see
2.
connector (see
figure
Use the PCS program to set the output resolution and rate, configure EDID Minder, adjust the video color bit depth, or
3.
monitor the signal and HDCP status, or other AV settings, as required. For details, see the HC 400 Series User Guide, or
access the PCS Help File (press <F1> on the keyboard or click the ? button in the software and select Help File).
To configure the AV settings using the OSD and front panel buttons:
Connect an HDMI display device to the HDMI/CEC output connector on the HCR 102.
1.
Power on the receiver and the display device, if they are not already powered on.
2.
Press the front panel Menu button on the HCR 102 (see
3.
the image at right). The OSD main menu appears on the display
(see the example below, at right).
The OSD menu system consists of the following menus:
•
Quick Setup
•
Picture Controls
•
Input
•
Output
and one read-only information screen (Device Info).
Navigate through the menus and make adjustments.
4.
Press the up
and down
a.
H
(see
) to navigate to and highlight the desired menu or
submenu.
Press the Enter button (
b.
to access submenu items for the selected submenu (see
Using the OSD menu to configure the AV settings
information about the contents of each submenu).
Press the up
and down
c.
and highlight submenu items.
Press the Enter or right arrow button to adjust a
d.
submenu item.
NOTE:
The OSD times out and closes after one minute if no
buttons are pressed.
LAN
on page 11.
A
2,
on page 2). USB connection requires a user-provided USB A to USB mini-B cable.
•
Audio
•
Advanced
•
Communications
arrow navigation buttons
G
) or right arrow button
arrow buttons to navigate to
N
figure
4,
on page 3) or the front panel Config USB
F
figure
2,
on page 2, or
Quick Setup
Picture Controls
Picture Controls
Input
Input
Output
Output
Audio
Audio
Advanced
Advanced
for
Communications
Communications
Device Info
Device Info
Menu button
MENU
HOLD
FOR 720p/1080p
ENTER
HCR 102
Enter button
Navigation buttons
7
Advertisement
Table of Contents
