Table of Contents
Advertisement
HC 402 • Setup Guide (Continued)
HDMI/CEC
Connect an AV device that supports CEC control to the
HDMI/CEC output port on the receiver (see
page 3) to allow the HCR 102 to automatically turn display
power on or off based on whether an active signal is detected at
the selected input.
The HCR 102 sends CEC driver commands to the display for basic control functions. CEC control is pre-configured and works
"out of the box" but it can be customized further using GC.
NOTE:
It can take up to 2 minutes after powering up the receiver to initiate CEC display control.
Power
ATTENTION:
• Always use a power supply supplied or specified by Extron. Use of an unauthorized power supply voids all regulatory
compliance certification and may cause damage to the supply and the unit.
•
Utilisez toujours une source d'alimentation fournie par Extron. L'utilisation d'une source d'alimentation non autorisée annule toute
conformité réglementaire et peut endommager la source d'alimentation ainsi que l'unité.
For port locations, see
figure 3
•
Connect the included 12 VDC, 4.2 A power supply (Extron PS 1242) at the receiver to remotely power the transmitter.
HCT 101 D
HCT 101 D
Rear Panel
Top Panel
OUT
HCT 101 D
NOTE:
The receiver can provide power remotely to the transmitter using a 50 watt power supply. Remote power mode
requires at least 2.5 A. The transmitter can receive power from but cannot provide power to the receiver. The remote
power feature is enabled by default but can be disabled by using a control in the PCS software.
12
G
figure
3,
and
figure
4,
A
on page 3. You have two options for powering the system:
AV, Communication, Power
Remote Power:
50 watt Receiver Power Input
• Receiver front
• Connect an
panel LED (
)
blinks during
R
boot-up and
remains lit
when the unit
is powered
and
operational.
HCR 102
Front Panel
OUTPUTS
LINK
L I
L
I N
N
N K
K
K
on
HDMI/CEC
HCR 102 Rear Panel
INPUTS
SIG
POWER
12V
1
TP
2.0A MAX
HDMI
– Return
+12 VDC input
included
12 VDC, 4.2 A
power supply to
the receiver only.
The receiver
supplies power
to the
transmitter.
MODEL 80
A
A
A
A
A
AUDIO
U
U D
U
D
D IO
D
D
D
O
O
O
L
L
L
L
L
L
R
R
HDMI
CEC
CEC-Compliant Display
LINK
OUTPUTS
COM
IR
DIGITAL I/O
AUDIO
L
R
IN
HDMI/CEC
Tx Rx G
S G
1
2
To AC power
Ridged
Smooth
Extron P/N 28-394-07LF )
FLAT PANEL
HCR 102
Rear Panel
HCR 102
G
3
4
G
LAN
Ground all devices.
External
Power Supply
(12 VDC, 4.2 A max.,
Advertisement
Table of Contents
