Installing The 2.3/2.5 Ghz Detached Antenna; Wall Mounting The 2.3/2.5 Ghz Detached Antenna - Alvarion BreezeMAX PRO-S CPE Product Manual

2.5 Installing the 2.3/2.5 GHz Detached
Antenna
The detached antenna kit includes the following components:
ALA05-050320 antenna
Torque Key (see picture to the right)
2 meter SMA-SMA (M/F) RF cable
Simple wall mounting kit, enabling installation on a wall
(without any capability for adjusting the direction). For
installation instructions see
Window mounting kit with tilt capability, enabling installation on a glass
window (with rotation capability for adjusting the direction). For installation
instructions see
Wall mounting kit with rotation capability. For installation instructions see
Section
NOTE
Ensure that the antenna is mounted vertical to the floor, with the connector facing downward, and
the front of the antenna facing to the exterior of the building, preferably directed towards the Base
Station.
2.5.1 Wall Mounting the 2.3/2.5 GHz Detached
Antenna
The installation kit includes 2 plastic anchors and 2 #8 screws.
If anchors are needed (wall-board, plaster board, etc.), drill two holes for the
1
anchors using a 5 mm drill bit and insert anchors. Use a 9/64" drill bit for
screwing directly into a solid surface (stud).
Fasten the antenna to the wall. Refer to
2
two #8 screws provided with the kit. Do not over tighten.
Connect the antenna cable to the connector located on the bottom side of the
3
antenna. Use only the torque key supplied with the antenna. Do not over
tighten. Do not use a wrench or a similar tightening tool.
BreezeMAX CPEs Product Manual
Section
Section 2.5.2.
2.5.3.

Installing the 2.3/2.5 GHz Detached Antenna

→
2.5.1.
Figure 2-19 for directions. Use the
51