Alvarion BreezeMAX PRO-S CPE Product Manual page 56

Chapter 2 - Installation
It is assumed that the IDU-ODU cable is already connected to the ODU.
1
Assemble an RJ-45 connector with a protective cover on the indoor end of the
IDU-ODU cable. Refer to
cable.
Connect the IDU-ODU cable to the RADIO connector. The RADIO connector in
2
the CPE-IDU-1D is located on the front panel as shown in
CAUTION
Do not connect the data equipment to the RADIO port. The RADIO port supplies DC power to the
ODU, and this may harm other equipment connected to it.
Connect the power cord to the unit's AC socket, located on the rear panel.
3
Connect the other end of the power cord to the AC mains after verifying that
the unit is rated for the voltage in the country of use; the AC range is indicated
on the back side of the CPE-IDU-1D.
NOTE
The color codes of the power cable are as follows:
Brown
Blue
Yellow/Green
Verify that the POWER LED located on the front panel is lit, indicating that the
4
unit is supplying power to the radio port.
Configure the basic parameters and align the antenna as described in the
5
applicable sections of
Connect the 10/100 Base-T ETHERNET connector(s) to the data equipment.
6
The cable connection should be a crossed Ethernet if connecting to a
hub/switch and a straight cable if connecting directly to a PC Network
Interface Card (NIC).
NOTE
The length of the Ethernet cable connecting CPE-IDU-1D to the user's equipment, together with the
length of the IDU-ODU cable, should not exceed 100 meters.
Verify proper operation as described in the applicable section of
7
34
Section 2.1.6.3
Phase ~
Neutral 0
Ground
Chapter 3.
for instructions on preparing the
Figure
BreezeMAX CPEs Product Manual
2-9.
Chapter 3.