2.3.3
RESET Button
NOTE
RESET button is not available in units with RF Version 11.
The RESET button is located on the bottom side of the unit:
NOTE
* WI-FI option is not supported in the current version. The slot is used for connecting to Si-V.
Press the recessed RESET button briefly (for less than 5 seconds) to reset the unit
and restart the network entry process. The unit will try for 60 seconds to connect
to the last used AU. If not found, it will try the next AU in the best AU list. The
same behavior shall be implemented for power-up.
Press the RESET button for 5 seconds and more to load the factory defaults and
reset the unit after 6 seconds, to perform full scan with factory defaults. If the
Installation Utility application is connected the user will be requested to confirm
the operation.
BreezeMAX CPEs Product Manual
Figure 2-13: Si CPE Bottom View
Installing the Si CPE
39