Status Indication; Power Connector - Hirschmann OWL3G User Manual

Router Design
3.6.1

Status Indication

There are three LED indicators on the front panel and two LED indicators on
every port, that provide information about the port status.
Caption Color
Power Green
WAN
DA Red
ETH0 Green
ETH1
ETH0
ETH1
SIM1
SIM2
Table 3: Router Status Indication
The WAN status is updated every 10 seconds. The WAN LED displays the
current status.
3.6.2

Power Connector

Panel socket 2-pin.
26
State Description
Blinking Router is ready
On Starting of the router
Fast blinking Updating firmware
1x flash per sec. Signal strength is from -50 dBm to -69 dBm
2x flash per sec. Signal strength is from -70 dBm to -89 dBm or
difference between neighbors cells is exactly 3 dBm
3x flash per sec. Signal strength is from -90 dBm to -113 dBm or
difference between neighbors cells is smaller than 3
dBm
Blinking Communication in progress on radio channel
On Selected 100 Mbit/s
Off Selected 10 Mbit/s
On The network cable is connected
Blinking Data transmission
Off The network cable is not connected
On SIM card 1 is active
On SIM card 2 is active
3.6 Description of the Front Panel
UM Installation OWL3G
Release 1.0 06/2015