Replacing Groovy Belt Wraps - Roundup VCT-250 Equipment Manual

RAPID TOASTER VCT-250

Replacing Groovy Belt Wraps

NOTE: Follow Steps 1-3, page 12 if necessary.
1. Locate the Hinge Flap on the Groovy Belt Wrap,
if the Hinge Flap is not visible; plug in the power
cord and turn the unit on, press down on both
Conveyor Safety Interlock Switches (Figure 11)
and wait until the flap is exposed and centered.
Turn the unit off and unplug the power cord, lift
flap, remove the Hinge Pin, and carefully remove
the Groovy Belt Wrap from the unit (Figure 14).
Discard this belt. Repeat this process for the rear
(Crown) side.
2. Install the new Groovy Belt Wraps with the Hinge
Flap hanging down and the wavy lines facing out,
as shown in Figure 16.
NOTE: The Groovy Belt Wraps must be installed
inside the yellow Support Rods. The flap, which
covers the connecting hinge, is located on the
(wavy) side of the belt. The (wavy) side should be
installed facing the outside of the toaster. The flap
should be in the down position (Figures 14 & 16).
CAUTION
Be sure the Groovy Belt Wrap is positioned INSIDE
the upper and lower yellow Support Rods or damage
to the Groovy Belt Wraps will occur.
3. Close the front and rear Conveyor Covers by lift-
ing the covers and gently pushing upward and
into the toaster until the covers latch onto the yel-
low Support Rods.
NOTE: Make sure both Conveyor Safety Interlock
Switches are activated when the covers are
installed (Figure 11) or the conveyors will not
rotate.
MAINTENANCE (continued)
14
Belt Wrap Pin
Figure 14. Replacing Groovy Belt
INCORRECT CORRECT
Figure 15. Aligning Belt Teeth
P/N 1010776 Rev. H 03/04
McDonald's