Unbind And Unload Commands - 3Com TokenLink Velocity XL 3C359B User Manual

Instructions in this section are written for TokenDisk
diskettes. If you are using the TokenLink Velocity XL CD,
substitute the appropriate path (using the \DISK_2
designation at the start of the path) where required.
1 At the Load LAN Driver menu, insert TokenDisk
diskette 2 into the drive.
2 Press Insert to load an unlisted LAN driver, and then
follow the prompts to specify the driver load path.
3 At the next menu, enter the following path:
a:\netware\nwserver\41x_5.0
After a short delay, a menu appears, showing the
TLNKPODI.LAN driver.
4 Press Enter to select the TLNKPODI.LAN driver.
5 When asked if you want to copy the driver (to
SYS:SYSTEM), respond Yes.
The next menu shows the parameters that can be used
with the 3C359B token ring NIC driver.
6 Press Enter to view a list of supported options for the
selected parameter.
Additional help for the parameter is also displayed in the
lower text box. You can also find a description of
parameters and explanations earlier in this chapter in
"Using the LOAD Command."
7 After you have made selections for all 3C359B NIC
driver parameters, press F10 to save the parameters
and load TLNKPODI.LAN. Then follow the prompts to
complete the server installation.

UNBIND and UNLOAD Commands

You can use the UNBIND or UNLOAD commands to remove
a driver (or logical board). The commands have the format
shown below:
unbind ipx tlnkpodi <name>
unload tlnkpodi
The UNBIND command requires only that you reenter
the BIND command, and does not affect the LOAD
command. You can selectively unbind a protocol for a
Installing a NetWare Server Driver 53