Before Using The Intelligent Auto Install Utility; Modifying Intelligent Auto Install Default Settings; Running The Intelligent Auto Install Program - 3Com TokenLink Velocity XL 3C359B User Manual

32 C 3: N
HAPTER
Modifies the CONFIG.SYS, AUTOEXEC.BAT, and
NET.CFG files. (The previous versions of these files are
renamed CONFIG.3CM, AUTOEXEC.3CM, and
NET.3CM.)
The Intelligent Auto Install utility is a DOS application. It
cannot run in a Windows NT or Windows 95/98 DOS
window, and it cannot be used to install an OS/2,
Windows NT, or Windows 95/98 client. For these operating
systems, use the manual installation procedure described
later in this chapter.

Before Using the Intelligent Auto Install Utility

Make sure that the following steps have been performed
before using the Intelligent Auto Install utility:
The 3C359B NIC is installed in your DOS-based PC and
is connected to the network.
NetWare version 3.12 or 4.1x is installed on the server.
A NetWare user account is available with a user ID
and password.
DOS version 3.2 or later is installed on the client PC, and
the PC has been booted under DOS.
The PC has at least 1 MB of free hard disk space.

Modifying Intelligent Auto Install Default Settings

Use the COMSLINK.CFG file to modify the Intelligent Auto
Install process. The COMSLINK.CFG file in the \COMSLINK
directory on TokenDisk diskette 1 (or on the TokenLink
Velocity XL CD) contains default settings and descriptions
of the COMSLINK parameters.
See the COMSLINK.TXT file in the \COMSLINK directory for
information on customizing Intelligent Auto Install and
server support.

Running the Intelligent Auto Install Program

The Intelligent Auto Install program loads the NetWare
DOS ODI 16-bit client driver. To run the Intelligent Auto
Install program, follow these steps:
1 Install the 3C359B NIC and connect it to the network
as described in Chapter 2.
N W E
OVELL ET ARE NVIRONMENTS